For a complete model set will build an 84′ for bucket elevator if you use all the parts.
NOTE: use an Evergreen Styrene #259 rectangular tube inside the parts to aid in alignment and to help solidify the model during assembly. It’s a snug fit and will help alleviate any glue seepage from joint seams.
ALSO: after removing from supports, grab a piece of 150/180/220 regular sandpaper and wet sand the bottoms where supports were attached in a circular motion on a flat surface. This will give you a pretty seamless transition between parts and only takes about 15 mins to prep the parts.
This model is designed by Focus Creative Studio and FCS is a trademark of Focus Creative Studio
Reviews
There are no reviews yet.